But again, who cares because you aren't supposed to scale drawings anyway. If we wanted to be serious about this, we would not ever show scale, and we would have a little + in the title block, with a note that says 'If these lines are not 1' long this drawing has not been reproduced accurately'.

Ever.And yet we show them a scale on all of our non 3D drawings. Contractors should never be scaling drawings. The video included here for PointCloud to Surface shows quite clearly how it works and how much time it can save you - Any further questions please contact support, they may consider setting up a short 1-2 day trial depending on your circumstances.Scales are important for reproduction. Best of Luck Hi Avinash, Sorry we can't offer a 30 day trial on this app, although we do offer 30 day trials on XYZ to Roof and XYZ to Floor which were our pre-cursors for this app, and offer similar functionality. The video included here for PointCloud to Surface shows quite clearly how it works and how much time it can save you - Īny further questions please contact support, they may consider setting up a short 1-2 day trial depending on your circumstances. Sorry we can't offer a 30 day trial on this app, although we do offer 30 day trials on XYZ to Roof and XYZ to Floor which were our pre-cursors for this app, and offer similar functionality. Note: App must be purchased with the same Autodesk account which is used to log in to Revit or the App will not run. Works with both structured and unstructured pointcloud instances. The section box can be used to filter out points on a broad scale, so by working in 3D view the section box in conjunction with the user drawn selection box allows very specific filtering of points to be added to each new element. For roofs and floors, you can select the build type and level for the new element. The app allows you to draw a selection box around the points of interest then select whether they should be mapped as either a topo, floor, or roof element. It reads laser scan data captured onsite and imported into Revit, automating the tedious process of manual point entry needed to create complex surfaces in a BIM model. This app has been designed for surveyors, architects, builders, and developers working on as-built projects.

Offers a decimation slider so that you can choose how many points are used to make the new surface element, for either high accuracy or high speed depending on your requirements. Work directly in Autodesk® Revit® with Pointcloud instances to create topo, floor, and roof elements that accurately match the original pointcloud data.

Scale upa 3d view revit 2011